|Lifting Speed:||5-15M/MIN||Trolley Running Speed:||20-40M/MIN|
|Crane Running Speed:||50-100M/MIN||Control Method:||Cabin Control/wire Rope Remote Control|
|Protection Grade:||IP54||Insulation Grade:||H|
double girder crane,
workstation bridge crane
30T QDY Type Metallurgical Motor-Drive Bridge Overhead Crane
30T QDY Type Metallurgical Motor-Drive Bridge Overhead Crane,of a double-girder single-cab structure,is mainly composed of bridge,cab,connecting traverse,trolley travelling mechanism and electric part. The main hook employs the constant-spacing connecting traverse as the load handling device to hoist steel ladle and the auxiliary hook acts in concert with the main hook to accomplish pouring of molten steel and steel slag,and other auxiliary hosting.
QDY Type Metallurgical Overhead Crane Lifting Clamps
The lifting clamp that serves as metallurgy to lift equipment is specific use is stronger, it is to be used commonly to lift finalize the design finished product article, it basically is the friction force between the clamp mouth that relies on holding appliance and be held article to come true lift carries article. Therefore, according to the way of generating clamping force, lifting clamps can be divided into two categories: lever clamps and partial clamps.
In order to improve the safety of metallurgical lifting equipment and extend its service life, the main body of lifting clamps is generally forged with high quality low carbon steel and high quality low carbon alloy steel, and also has a higher strength and toughness. And the component such as its pliers mouth, pliers tongue also adds wear-resisting material and processing has antiskid groove, in order to prevent excessive wear and the slippage of the hanging material in the work.
When lifting objects with lifting clamps, they shall not collide with other objects; And in addition to lifting pliers of vertical lifting steel plate, not unilateral lifting steel plate, also requires steel plate thickness should be in the lifting pliers lifting thickness range, it seems that its requirements are very strict.
For the lifting clamps of the vertical lifting steel plate, the clamps can only clamp a piece of steel plate at a time, prohibit stack lifting, will bring security risks. And no matter which kind of metallurgical equipment, it is necessary to operate in accordance with the relevant instructions, procedures, lifting clamps are the same, to avoid one side of the clamping is not firmly lifted when the pop-up injury.
Since its specificity is very strong, this steel plate clamp must be used in accordance with its function, must not be used for other purposes, may cause an accident.
Contact Person: Mr. June Chao
Tel: 0086 18568525956